AVG 5/8x24 Nitride

The AVG attaches to our Atlas adapters, making them compatible with most suppressors on the market.

The AVG uses a 13/16 wrench.

The 5/8-24 bore size is compatible with calibers up to .338 in size. The 1/2-28 bore size is intended for 5.56/.223 The AVG is NOT compatible with 350 legend, 9mm, etc

• Black Nitride Finish
• Atlas and Atlas XL Compatible
• Plan B Compatible

Shims Not Included, if you would like to specifically time this, shims will be required. Note: your barrel may require a shim if the manufacturer did not put a thread relief on it.

Always use an alignment rod to ensure that the entire system is set up correctly. Make sure all surfaces are cleaned and the muzzle device has been torqued and Rockset to the barrel.  Use on a Q can voids your warranty, be warned.

Torque the muzzle device to approximately 15-25 ft lbs. Make sure the muzzle device is square against the shoulder. When setting the silencer on the muzzle device, ensure that the threads and tapers are clean. Torque the suppressor to 10 ft lbs. Ensure alignment. Enjoy. The nitride finish does lead to a tighter seal, with that said, it is extremely important to torque and rockset your muzzle device to the barrel properly.